This is an extremely rare example of the original North American Arms Company "Prototype" Model 1911 semi-automatic pistol. In July 1918, the U.S. Government issued a contract for 500,000 M1911 pistols to the North American Arms Co. Ltd. of Quebec City, Quebec, Canada. The North American Arms Co. leased the Ross Rifle plant to do the manufacturing, and the U.S. Government was to supply all the raw materials. However, due to wartime material shortages, they only supplied enough material to produce approximately 100 sets of prototype or tool room parts. Due to the WWI Armistice, the contract was canceled in December of 1918 with no pistols being fully completed or ever accepted by the U.S. Government. The U.S. Ordnance Salvage Board did eventually accept/reclaim this large lot of parts and assemblies as part of the contract termination settlement, and they were later disposed of. Some time later, those 100 sets of parts were assembled into complete pistols that were uniquely marked with only a controlling serial number on the left rear section of the slide along with the factory markings also on the left side of the slide. This specific pistol is obviously an original prototype or tool set up example as the major components are still in the white while the smaller parts are blued, and all of them are fully machined. The only markings are on the left side of the slide, "ERNEST J. EVANS/1-1918 - N.A.A. QUE." The "N.A.A. QUE." is the abbreviation for North American Arms, Quebec. "ERNEST. J. EVANS" has not been positively identified, but the marking was marked the same way as the North American Arms marking. It is presumed he was involved in the company. An Ernest J. Evans in Quebec is listed as the commander of Commanderie et Prieuré William de la More le Martyre No 25 de l’Ordre du Temple in 1913 and 1922, but additional information on this individual as well as the company is elusive. The pistol itself is beautifully machined, and the configuration of the parts and components are identical to the standard Colt Model 1911s. It has Colt blued small parts such as the barrel bushing, magazine release, hammer, grip safety, thumbpiece, and slide stop and Colt manufactured grips and magazine. The pistol is very well machined, polished, and assembled unlike others we have seen, which may indicate this was actually one of the factory produced and assembly models. The hammer is a wide version very similar to the Colt production models, and the grip panels are the standard WWI diamond checkered walnut versions. The magazine is a blued half-tone pattern similar to a Colt commercial magazine and has the letter "R" on the lip of the base plate.

Excellent with all the major components still in their original white except for the hammer, grip safety, slide stop lever and thumb safety, which are all blued. As noted, it still retains its original early WWI pattern walnut grips that are in very fine condition. The pistol itself has dried grease along the edge of the parts and barrel from where it has been sitting. A very scarce and one-of-a-kind North American Arms Prototype M1911 pistol.