This is an excellent example of a late production Danish Model 50 submachine gun chambered in 9 mm Luger. The Model 50 is actually an update version of the earlier M1946 produced right after WWII. Both used many of the wartime expedient stamped steel manufacturing processed parts developed during WWII. The really interesting aspect of this model is that it is manufactured from two separate stamped steel receiver halves that are hinged at the rear of the receiver and are held together on the front end by the barrel nut. Although it seems very unconventional, it proved to be an extremely reliable and accurate submachine gun. This model was originally demonstrated for military testing in Canada in November 1950 that was also witnessed/attended by representatives from Britain, the U.S. Army, and Denmark. In that test, a single M50 SMG successfully test fired over 20K rounds of ammunition in a little over 2 1/2 hours with no failures. As noted, it uses many stamped steel parts except for the barrel and bolt, both of which are machined. It has a right side, folding wire type stock, a grip safety behind the magazine well, and side mounted sling swivels. It has a simple non-adjustable peep rear sight on the rear of the receiver and a blade front sight. The side of the receiver is stamped with serial number "56030" followed by "MADSEN M50 9mm" and below that it is stamped "MADE IN DENMARK". It comes with one original 30 round stick magazine and original canvas sling. This late production is so new that it still retains the original leather cover on the wire stock.

Excellent with 98% plus of the original black painted exterior finish overall with only minor high spot wear overall. Mechanically excellent. NOTE: This item is restricted as a National Firearms Act (NFA), fully transferable Class 3, which is registered with the Bureau of Alcohol, Tobacco, Firearms and Explosives, (BATFE) that is classified as a "Curios or Relic" as defined in 27 CFR, 478.11. These weapons are still subject to the provisions of 18 U.S.C. Chapter 44 and 27 CFR part 478.