Model 1836 Hall breech loading carbine that was manufactured by the U.S. Armory at Harper's Ferry, Virginia, between 1837 and 1840. The Harper's Ferry Armory made 2,020 Model 1836 Hall carbines between 1837 and 1840; most of these carbines were intended for issue to the U.S. 2nd Dragoon regiment. The Model 1836 carbine has a distinctive 22 inch sliding angular bayonet located in a v-shaped groove below the smooth bore barrel. Model 1836 carbines utilized some components from the Hall Model 1819 Flintlock rifles including the breechblock with high fence rifle trigger guard that is not drilled for a sling swivel and off-set rear sight. The rifle has two pin-fastened iron barrel bands, a spur-shaped breech lever, and sling ring that consists of an eye-bolt, which passes entirely thru the stock and is secured by a spanner nut on the right side of the stock wrist. This carbine has the later pattern stock which lacks the hinged implement box cover found on many Model 1836 carbines. The hammer lacks the hole below the spur found on most Model 1836 carbines. The breechblock has a casehardened finish, the bayonet is bright; the barrel, buttplate and furniture have a brown lacquer finish. The stock is oil-finished black walnut. The top of the breechblock is stamped "J. H. HALL/H. FERRY/US/1834" in four lines ahead of the hammer. There are no other markings on the carbine.