Starting in September of 1920, the Ordnance Board began to make suggestions for modifications to the Model 1911 pistol based on experience from World War I, and by April of 1923 OCM Item 2890 was standardized and recommended by the department. A pilot series of 10,000 pistols was approved with some production issues arising throughout 1923, but by January 1924 the first "Improved Models" were being delivered and were also known as the Transitional Model 1911s. This example was shipped on 22 January 1924 to Springfield Armory. While they retained the nomenclature markings of the 1911, they were equipped with the signature features of the 1911A1 which included the dished frame sides, shortened trigger, elongated grip safety, and arched mainspring housing. Fitted with round blade front and flat top notch rear sights, with the two-line, two-block address and patent markings divided by the Rampant Colt logo on the left side of the slide, "MODEL OF 1911.U.S.ARMY" on the right, and "H" above the firing pin stop plate. The frame bears the circular Walter Gordon "WTG" inspection stamp, with the short milled checkered trigger, wide checkered hammer, long grip safety, checkered mainspring housing with lanyard loop, a conjoined "HP" marked barrel, and an unmarked two-tone magazine. Provenance: The Dr. Robert Azar Collection

Very fine, retains 85% plus of the original brushed blue finish with extensive scattered patches of light surface oxidation on the right of the slide and some scattered light pitting, primarily on the front strap and right of the slide. The grips are also very fine with a few scattered light blemishes in the overall crisp checkering. Mechanically excellent.