This is an example of the exceptionally rare and iconic North American Arms Co. Model 1911 pistol, that was produced in December of 1918 in Quebec, Canada. In early July 1918, the U.S. Government issued a contract for 500,000 Model 1911 pistols to the North American Arms Co., previously the Dominion (Ross) Rifle Plant. The company leased the plant for manufacturing and as part of the contract, the U.S. Government was to supply all of the raw materials necessary for production. However, due to material shortages during the war and the time it took the plant to get tooled up for production, the Government was only able to supply enough material to produce approximately "100 sets" of initial start-up or prototype parts. Due to the armistice of November 1918, the contract was canceled in December of 1918 with no examples of completed pistols ever being accepted by the U.S. Government. As part of the contract termination settlement, the U.S. Ordnance Board did eventually accept/reclaim a large portion of the manufactured and completed parts and assemblies, most of which were later disposed of. Some however, were later assembled into completed pistols. These 100 pistols were uniquely stamped with only a controlling serial number in two locations, the left lower area of the frame under the grip panel, and the left upper rear corner of the slide, with this exampled numbered "94". Bady theorizes that the unique placement of the serial numbers on the known "standard" examples of the North American Model 1911s suggests that none were ever submitted for government approval, which would indicate that the pistols were assembled after the suspension of the contract. Information on these "standard" examples from North American can be found on p. 219-221 of "U.S. Military Automatic Pistols 1894-1920" by Meadows and on p. 201-204 of "Colt .45 Service Pistols: Models of 1911 and 1911A1" by Clawson. The left side of the slide is marked "MANUFACTURED BY/NORTH AMERICAN ARMS CO. LIMITED/QUEBEC, CANADA." and "94" behind the serrations, which is repeated under the left grip on the frame. A "9" is visible on the left of the trigger. It is fitted with a serrated slide stop, checkered thumb safety, checkered magazine catch, short grip safety, smooth hammer, correct smooth straight mainspring housing with no lanyard loop, correct rounded tip barrel bushing, checkered diamond pattern grips, and an unmarked, full blue, replacement pinned based magazine. Barrel is an "S" marked replacement with polished chamber hood. Provenance: The Gus Cargile Collection
Very good, retains 30% of the original blue finish with the balance showing mostly a mottled grey-brown patina and a few patches of moderate pitting, primarily on the slide. The grips are very fine with a few light chips around the screws, a few scattered light handling marks, and crisp checkering overall. Mechanically excellent.